loader

The new 1140 Linear In-Grade Lighting Series

Fewer Fixtures.
Greater Efficiency.

In-grade lighting meets
outstanding performance.

Our new 1141 and 1142 Linear LED In-Grade fixtures deliver more lumens — up to 2,100 per linear foot — giving you more effective lighting power, lower overall cost and a perfect architectural lighting solution for any recessed-application challenge.

Two models.
One powerful lighting solution.

Both the 1141 and 1142 offer exceptional lighting output compared to similar in-grades in the industry.

1141

Linear LED In-Grade Luminaire

15 3/8” length, 4 5/8” width, up to 2,100 lumens per linear foot

Learn More

1142

Linear LED In-Grade Luminaire

26 3/8” length, 4 5/8” width, up to 1,845 lumens per linear foot

Learn More

1140 Series Specifications 1140 Series Sell Sheet

FIXTURE CONSTRUCTION

Aluminum/polymer construction with fully sealed interchangeable optics and a flow-through recessed housing. Drive-over rated when installed in concrete.

OPTIONS

Internal glare shields

LENS

10mm (.393") thick tempered and beveled clear glass. Permanently affixed and sealed to the optics housing with RTV silicon. Masked frit opening (black finish only) or brushed stainless steel bezel option available.

COLOR AND COLOR TEMPERATURE

3000°K, 3500°K, 4000°K or 5000°K static white offerings available.

OUTPUT

Lumen range from 1,845–2,100 lumens per linear foot.

OPTIC MODULE CONSTRUCTION

Extruded/die cast aluminum construction, Type III hard anodized for maximum corrosion protection. Module is wet location listed, fully sealed with optics and integral drivers internal to the optic module. The optic module snaps into the RIS using two spring tempered stainless steel clips. Electrical connectors are made via outdoor rated cabling and watertight connectors.

OPTICS

Wall Wash (WW), Wall Grazing (WG), Narrow (NS), Medium Flood (MF) and Wide Flood (WF) distributions available.

VOLTAGE

1141: 120–277
1142: 120 or 277

DRIVERS

ELV, TRIAC, 010VDC dimming.

CERTIFICATION & LISTING

UL-Listed. IP68-Rated. Made in USA.

Glare Shield
Accessory Options

Effective light control is paramount with higher output LED fixtures. The 1141 and 1142 glare shields are positioned under the tempered clear beveled glass to the edge of the reflector opening. The glare shield extends from the peripheral edge of the reflector and serves to reduce and block off-access glare, whether direct or reflected from the light source. They have been designed to have little, if any, impact on the intended lighting needs.

Learn more about
the 1140 Series

Contact Us      1140 Series Sell Sheet